Starting Charging/Discharging In Manual Mode; Bid Chip/Key - Multiplex Power Peak B6 EQ-BID Notice D'utilisation

7.4

STARTING CHARGING/DISCHARGING IN MANUAL MODE

8.

BID CHIP/KEY

Insert
chip
Withdraw
chip
Operating Instructions
Power Peak ® B6 EQ-BID
tery pack.
MODE button.
played once again (if not OK, correct values).
cess, an acoustic signal indicates the
status. The working display, containing all impor-
tant parameters, is then shown (see Section 5.2).
current during the charging procedure, the new
value flashes before being adopted.
As soon as a BID chip/key is connected to the char-
ger from the start display or from any other menu on
the set-up level the charger switches to the mode
for charging/discharging a battery with BID chip/key
or for programming a BID chip/key. All parameters
for the battery, for which this chip is to be used, can
be set from this menu. In addition, stored charge
or discharge values can be read (see Section 8.3).
The programming menu is exited on removing a BID
chip/key and the Start display is shown again.
17 49
# 30 8561
-
-
-