Connecting The Battery - Multiplex Power Peak B6 EQ-BID Notice D'utilisation

for lead battery) is shown on the bottom line. The display therefore shows all important
parameters at a glance during a charging or discharging operation.
5.3

CONNECTING THE BATTERY

Important!!! Make sure to check all the set parameters once again before connecting
a battery pack. The battery may be damaged, explode or catch fire if the settings are
not correct. To avoid a short-circuit with the banana plugs, always connect the charging
leads to the battery charger first and then to the battery. Follow the reverse procedure when
disconnecting. Ensure correct polarity!
Equalizer connection:
The black wire of the voltage sensor lead from the battery must be connected to the char-
ger at the arrow marking. The arrow marking indicates the earth pole (negative). Ensure
correct polarity!
This example only serves as a reference and is intended to demonstrate the connection of the vol-
tage sensor lead to the equalizer.
EQ adapter
Multiplex-PQ No.308213
Operating Instructions
Power Peak ® B6 EQ-BID
Accessories:
EQ adapter
Multiplex-JSTXH No. 308214
41 9
EQ adapter
Multiplex-TP/FP No. 308215
# 30 8561