Cleaning The Jet Plate; Replacing The Filter - Franke AQUA623 Notice De Montage Et De Mise En Service

Removing the stainless steel housing
Some maintenance work requires that the stainless steel housing be removed.
16.1 Only when the water connection is from the top:
Close the flow volume regulator.
a: closed
b: open
16.2 Only when the water connection is from the top:
Trigger the valve.
Disconnect the connecting hose for mixed water or cold water from the water volume
regulator.
16.3 Loosen the screws on the stainless steel housing.
☞
Do not let the stainless steel housing hang by the connecting hose.
16.4 Unhinge the stainless steel housing.
16.5 Only when the water connection is from the rear:
Close the flow volume regulator (see
16.6 Only when the water connection is from the rear:
Trigger the valve.
Disconnect the connecting hose for mixed water or cold water from the water volume
regulator.

17. Cleaning the Jet Plate

17.1 Loosen the screw with a hollow hexagon wrench.
17.2 Using a screwdriver, carefully lift out the jet plate.
17.3 Clean the jet-plate.
17.4 Reassemble in the reverse order.

18. Replacing the Filter

Filter for water volume regulator
18.1 Remove the stainless steel housing (see
18.2 Unscrew the screw plug (a) on the water volume regulator.
18.3 Replace the filter (b).
☞
Important!
Ensure that the filter is positioned the right way round.
18.4 Reassemble in the reverse order.
Work step 16.1).
Chapter 16.).
- 10 -