Emptying The Dust Drum; Blowing Feature - RIDGID HD06000 Mode D'emploi

SP7030-1 HD06000 HD09000 2018.qxp_HD0600 HD0900 3/7/18 1:55 PM Page 10
OPERATION

Emptying the Dust Drum

WARNING: To reduce the risk of
injury from
unplug power cord before emptying
the drum.
1. Unplug Power Cord from power
source.
2. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
3. Lift Powerhead Assembly from the Dust
Drum and set aside.
4. Empty Dust Drum into a proper waste
disposal container.
Drum
Latches (2)
Dust
Drum

Blowing Feature

Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Insert the larger end of the Tug-A-Long
Positive Locking Hose with Dual-Flex
into the Blowing Port of the Vac.
Engage the Hose Latch to the lip of the
Blowing Port. The Hose should snap
into place.
accidental starting,
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
Blowing
Port
Hose
Tug-A-Long
Positive Locking
Hose with
Dual-Flex
10
Swivel
End of
Hose
Extension Wand
(Optional)