Emptying The Drum; Blowing Feature - RIDGID WD03180 Mode D'emploi

Operation (continued)

Emptying the Drum

!
WARNING: To reduce the risk of
injury from accidental starting,
remove battery before emptying the
drum.
1. To remove the lid , grasp the drum
latches on both the right and left side
of the power head. Slowly pull the
drum latches out and up from the
drum. Lift the power head off the
drum. Place the lid assembly to the
side.
2. Lay the power head on a clean dry
area while emptying the drum or
changing the filter.
3. Dump the drum contents into the
proper waste disposal container.

Blowing Feature

Your Wet/Dry Vac has the capability to
blow sawdust and other debris and to be
used as a blower for yard work, patio
cleanup and workshop applications.
NOTE: The blowing port is located
opposite the vacuum port.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
9