Maintenance; Qwik Lock™ Filter - RIDGID HD06000 Mode D'emploi

SP7030-1 HD06000 HD09000 2018.qxp_HD0600 HD0900 3/7/18 1:55 PM Page 12

MAINTENANCE

Filter
WARNING: To reduce the risk of
injury from
unplug power cord before changing
or cleaning filter.
NOTE: The Filter is made of high quality
paper designed to stop small particles of
dust. The Filter can be used for dry pick up
or small amounts of liquid. Handle the
Filter carefully when removing or installing
it. Creases in the Filter Pleats may occur
from installation but will not affect the
performance of the Filter.
Removal & Installation of the
Qwik Lock™ Filter
Filter Removal:
1. Place fingers under the two Filter Tabs.
2. While pressing down with one thumb
on the Qwik Lock™ Stud that protrudes
through the center of the Filter Plate,
lift up on the Tabs until Filter releases.
3. Slide Filter off Filter Cage.
IMPORTANT: To avoid blower wheel and
motor damage always reinstall filter before
using Vac for dry pickup.
Filter Installation:
1. Slide the Qwik Lock™ Filter over the
Filter Cage while aligning the Qwik
Lock™ Stud on the Filter Cage with the
center hole in the Qwik Lock™
Integrated Filter Plate.
2. Make sure the Rubber Gasket at the
bottom of the Qwik Lock™ Filter seats
around the base of the Filter Cage.
3. Firmly press
Integrated Filter Plate down around the
Qwik Lock™ Stud until it snaps into
place.
accidental starting,
the Qwik Lock™
NOTE: Failure to properly seat the bottom
Gasket and Integrated Filter Plate to the
Filter Cage could result in debris
bypassing the Filter.
WARNING:
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
Integrated Filter Plate
with Center Hole
PUSH
DOWN
PULL
UP
Your filter should be cleaned often to
maintain peak Vac performance.
12
Do not operate
Filter
Tabs (2)
PULL
UP
Rubber
Gasket at
Bottom of
Filter
Qwik
Lock™
Stud
Filter
Cage
Powerhead
Assembly