Bosch PSR Select Notice Originale page 33

The micro USB port (9) for connecting the micro USB cable (14) is located
in the handle. Connect the power tool to the charger (15) using the micro
USB cable (14) provided. Plug the charger (15) into the socket. The char-
ging process begins.
The battery charge indicator (5) indicates the charging progress. The indic-
ator flashes green during the charging process. When the battery is fully
charged, the battery charge indicator (5) goes out. If the battery charge in-
dicator (5) is lit up in red, the temperature of the battery is too high.
During the charging process, the handle of the power tool will heat up. This
is normal. If you are not planning to use the power tool again soon, discon-
nect the charger from the mains. The power tool cannot be used during the
charging process. It is not defective if it does not work during the charging
process. Follow the instructions on correct disposal.
Follow the instructions on correct disposal.
Inserting the screwdriver bits into the bit magazine (see
figures B–C)
wards.
Only insert one screwdriver bit per chamber into the bit magazine. Only
use short standard screwdriver bits. Longer screwdriver bits cannot be
loaded into the bit magazine.
Turn the bit magazine (11) until an empty chamber is visible in the viewing
window (3).
Push the sliding switch (7) forwards.
Insert the screwdriver bit (1) directly into the tool holder (2).
Push the sliding switch (7) backwards to load the screwdriver bit (1) into
the bit magazine (11).
Once you have pushed the sliding switch (7) backwards or pressed the on/
off switch (10) while it is in the rear position, the bit magazine (11) will be il-
luminated for approx. 20 seconds.
Bosch Power Tools
Wear safety goggles when chan-
ging the tool. Do not look directly
into the tool holder. When changing
the application tool, there is a pos-
sibility that it may be ejected out-
1 609 92A 4M5 | (24.10.2018)
English | 33