Bosch PSR Select Notice Originale page 31

The vibration level and noise emission value given in these instructions have
been measured in accordance with a standardised measuring procedure and
may be used to compare power tools. They may also be used for a prelimin-
ary estimation of vibration and noise emissions.
The stated vibration level and noise emission value represent the main ap-
plications of the power tool. However, if the power tool is used for other ap-
plications, with different application tools or is poorly maintained, the vibra-
tion level and noise emission value may differ. This may significantly in-
crease the vibration and noise emissions over the total working period.
To estimate vibration and noise emissions accurately, the times when the
tool is switched off or when it is running but not actually being used should
also be taken into account. This may significantly reduce vibration and noise
emissions over the total working period.
Implement additional safety measures to protect the operator from the ef-
fects of vibration, such as servicing the power tool and application tools,
keeping their hands warm, and organising workflows correctly.
Battery charging (see figure A)
Do not use any other charger. The supplied charger is matched to the
u
lithium-ion battery that is fitted in your power tool.
Note: The battery is supplied partially charged. To ensure full battery capa-
city, fully charge the battery in the charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Elec-
tronic Cell Protection (ECP)". When the battery is discharged, the power
tool is switched off by means of a protective circuit: The application tool no
longer rotates.
Do not continue to press the On/Off switch after the power tool has
u
automatically switched off. The battery can be damaged.
If the battery charge indicator (5) lights up red when you press the on/off
switch (10) half way in, the remaining battery capacity is less than 30% and
the battery should be charged.
The micro USB port (9) for connecting the micro USB cable (14) is located
in the handle. Connect the power tool to the charger (15) using the micro
Bosch Power Tools
English | 31
1 609 92A 4M5 | (24.10.2018)