Operation - Beurer EM 28 Mode D'emploi

6. Operation

General notes on use
Do not switch on the device until the cuff is correctly
positioned. See chapter 5.
The wrist TENS is intended for individual treatment of pain
in the wrist.
Switching on
Hold down the On/Off button [1] until a short signal sounds
and the LCD display [6] switches on. When the device is
switched on for the first time, program A is automatically
activated.
Selecting a program
Press the program button P [3] to switch between the
programs.
The following programs are available:
Program Frequency
A 4 Hz – 110 Hz (3 phases)
B 4 Hz
C 2 Hz (burst)
D 110 Hz
Note:
With program A, you will feel the effect become
stronger when the program changes from phase 1 to
phase 2 (after approx. 10 minutes). This is normal and
intentional. If the intensity seems too high, you can
lower it by simply pressing the intensity button ▼ [2].
Note:
If the program is changed during stimulation (for ex-
ample from A to B), the output intensity will increase
gradually in the new program until it reaches the
intensity that was previously set. This can be stopped
if required by pressing the intensity button ▼ [2] or by
switching off the device by pressing and holding the
On/Off button [1] for two seconds.
Stopping pulses that are too strong
You can lower the intensity at any time or turn the device off
by pressing and holding the On/Off button [1] (~ 2 seconds).
Setting the intensity
Time
Press the intensity button ▲ [2], to gradually increase the
30 min.
intensity, or the intensity button ▼ [2] to lower the inten-
sity. There are 20 levels of intensity that can be selected.
25 min.
Depending on the intensity level, you will start to feel tingling,
25 min.
which may increase up to muscle contractions.
25 min.
Select a setting that is comfortable for you during use.
26