Wiring Connection; Important - JVC KD-X340BTS Manuel D'instructions

INSTALLATION/CONNECTION

Wiring connection

(for KD-X340BTS)
JVC Amplifier * 1
Signal cord (not supplied)
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle
factory wiring harness does not
have "12 V ignition switch" wire.
36
ENGLISH
Output
terminals
( 35)
To the steering
Light blue/yellow
wheel remote
control adapter
Join the same color wires together.
Blue/white: Remote (12 V 350 mA)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/For 3-way crossover: Mid range speaker (right)
Gray/black
White: Front speaker/For 3-way crossover: Mid range speaker (left)
White/black
Purple: Rear speaker/For 3-way crossover: Tweeter (right)
Purple/black
2
Green: Rear speaker * /For 3-way crossover: Tweeter (left)
2
Green/black *
MIC (Microphone input
terminal) ( 14)
Antenna terminal
Expansion port (12 V 500 mA)
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
Blue: To power antenna
Blue/white: To amplifier
(Not used)

IMPORTANT

We recommend installing the unit with a
commercially available custom wiring harness specific
for your car and leave this job to professionals for your
safety. Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Brown
*
1
Firmly connect the ground
wire of the amplifier to
the car's chassis to avoid
damaging the unit.
*
2
You can also connect a
subwoofer speaker directly
using this lead without
an external subwoofer
amplifier. For setting, 24.
Recommended connection