Installation; Wiring Connection - JVC KD-SR60 Manuel D'instructions

Wiring connection

KD-SR60
Vehicle dashboard
Factory wiring
harness (vehicle)
Blue: To power antenna
Blue/white: To amplifier
Vehicle-specific Wiring
Harness (separately
purchased)
For more information:
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
KD-SR40
Front output
Rear/subwoofer
Rear/subwoofer
output
output
Antenna terminal
Recommended
Join the same color wires together.
connection
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Gray/black
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
Signal cord (not supplied)
JVC Amplifier
Fuse (10 A)
Ignition switch
Car fuse block
Separate
red wire
Make this connection if
your vehicle factory wiring
harness does not have
"12 V ignition switch" wire.
Part list for

installation

(A) Faceplate
(B) Trim plate
Remote wire
(not supplied)
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH |
17