Wiring Connection - JVC KD-R449 Manuel D'instructions

Wiring connection

For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the supplied
power cord D as illustrated.
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord
(not supplied)
Rear/subwoofer output
Rear ground terminal
Aerial terminal
If your car has an ISO terminal
( or )
If your car does NOT have an ISO terminal
* Custom wiring harness (separately purchased)
IMPORTANT: A custom wiring harness (separately
purchased) which is suitable for your car is
recommended for connection.
Remote wire
To Blue/white
(not supplied)
wire of the wiring
harness D
JVC Amplifier
Fuse (10 A)
ISO connector
B1 Purple ª
Rear speaker
B2 Purple/black · (right)
B3 Gray ª
Front speaker
B4 Gray/black ·
(right)
B5 White ª
Front speaker
B6 White/black · (left)
B7 Green ª
Rear speaker
B8 Green/black · (left)
A2 Brown: Mobile phone system
A4 Yellow: Battery
A5 Blue/white: Remote wire
Orange/white: Car light control
A6
switch
A7 Red: Ignition (ACC)
A8 Black: Earth (ground) connection
13
Part list for installation
A Faceplate
( ×1 )
B Mounting sleeve
( ×1 )
C Trim plate
( ×1 )
D Wiring harness
( ×1 )
E Extraction key
( ×2 )
ENGLISH