Getting Started - JVC KD-R449 Manuel D'instructions

GETTING STARTED

1
Set the clock
1
Press and hold MENU.
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK SET], then press the knob.
4
Turn the volume knob to select the day, then press the knob.
5
Turn the volume knob to adjust the hour, then press the knob.
6
Turn the volume knob to adjust the minute, then press the knob.
7
Turn the volume knob to select [24H/12H], then press the knob.
8
Turn the volume knob to select [24 HOUR] or [12 HOUR] then press
the knob.
9
Press MENU to exit.
2
Set the basic settings
1
Press and hold MENU.
2
Turn the volume knob to make a selection, then press the knob.
• See the following table for selection.
3
Press MENU to exit.
To return to the previous hierarchy, press G T/P.
DEMO DEMO ON: Display demonstration will be activated automatically if no operation is done for
about 20 seconds. ; DEMO OFF: Cancels.
CLOCK
24H/12H 24 HOUR/ 12 HOUR: Selects the clock format.
CLOCK ADJ AUTO: The clock time is automatically set using the Clock Time (CT) data in FM Radio Data
System signal. ; OFF: Cancels.
CLOCK DISP ON: The clock time is shown on the display even when the unit is turned off. ; OFF: Cancels.
DIMMER
DIMMER SET Selects the display and button illumination adjusted in the [BRIGHTNESS] setting.
AUTO: Changes between the day and night adjustments when you turn off or on the car
1
headlights. * ; ON: Selects the night adjustments. ; OFF: Selects the day adjustments.
BRIGHTNESS Sets the display and button brightness for day and night separately.
1 DAY/ NIGHT: Select day or night.
2 BUTTON ZONE/ DISP ZONE: Select the zone for setting.
3 Set the brightness level (00 to 31).
(Default: BUTTON ZONE: DAY: 25 ; NIGHT: 9 / DISP ZONE: DAY: 31 ; NIGHT: 12)
DISPLAY
2
SCROLL * ONCE: Scrolls the display information once. ; AUTO: Repeats scrolling at 5-second
intervals. ; OFF: Cancels.
TAG DISPLAY ON: Shows the TAG information while playing MP3/WMA files. ; OFF: Cancels.
SRC SELECT
3
AM * ON: Enables AM in source selection. ; OFF: Disables.
AUX * 3
ON: Enables AUX in source selection. ; OFF: Disables. ; BT ADAPTER: Select when the
KS-BTA100 Bluetooth adapter is connected to the AUX jack (➜ 7). The source name will
change to BT AUDIO.
* 1 The illumination control wire connection is required. (➜ 13)
* 2
Some characters or symbols will not be shown correctly (or will be blanked).
*
3 Not displayed when the corresponding source is selected.
4
Default: XX