Initial Operation; Setting Up - Parkside PHD 100 E2 Traduction Des Instructions D'origine

• Before each use, check the
equipment, cable and plug for
damage.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not pull the plug from the
socket by the cable. Protect the
cable from heat, oil and sharp
edges.
• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables that
are protected from spray water
and designed for outdoor use.
Always fully unroll a cable
drum before use. Check the ca-
ble for damage.
• Before any work on the equip-
ment, during work breaks and
in the case of non-use, remove
the plug from the socket.
• The cross-section of the power
supply cable must not be less
than 2 x 2,5 mm².
• Wear sturdy footwear to protect
against electric shock.

Initial Operation

In keeping with current regulations
a pressure washer must never be
operated off the drinking water
mains supply without a controlla-
ble backflow preventer. A suitable
backflow preventer in conformity
with EN 12729 type BA must be
used.
Water that has passed through a backflow
preventer is classified as undrinkable.
A backflow preventer is available
from specialist retailers.
• Employ an ordinary garden hose for
the water intake and ensure sufficient
length.

Setting up

• Insert the accessory holder
B
(6) into the attachment on the
reverse-side of the device (see
small image).
• Screw the equipment side of the
high-pressure hose connection
(2) to the high-pressure hose con-
nection (3) on the equipment.
• Insert the high-pressure connec-
tion on the gun side (1) into the
spray gun (10).
• Establish the water supply by
connecting the rapid-action wa-
ter supply connector to the water
connection with sieve insert
A
( 9).
• Connect to the spray gun (10)
C
by inserting and screwing in the
jet tube (11).
• If the jet pipe (11) is fitted, screw
in with the jet pipe (11) to con-
nect either the adjustable fan
nozzle (12) or the high pressure
nozzle (13).
• Screw in to connect the deter-
gent container with nozzle (
14) directly to the spray gun
(10). With using the cleaning
agent container with the noz-
A
zle ( 14), pour only cleaning
GB
A
35