Replacing The Sliding Washers; Replacing The Locking Pawl And The Step Lock Pawl; Cleaning - FIOR & GENTZ NEURO LOCK Notice D'utilisation

Boring and Reaming Measurements for NEURO LOCK MAX/NEURO FLEX MAX [mm]
System Bearing Nut
Width Outer Ø
12mm
7.0
14mm 8.5
16mm 9.6
20mm 10.5

12.2 Replacing the Sliding Washers

Sliding washers are available in different thicknesses (e.g. GS2210-040 is 0.40mm thick). Each thickness has
a different marking (fig. 36). You will find the article numbers of the premounted sliding washers on the back
page of these instructions for use.
0.40mm

12.3 Replacing the Locking Pawl and the Step Lock Pawl

If the locking pawl/step lock pawl or the stop disc/joint's lower part wears out, the pre-
mounted pawl has to be exchanged for a longer one. You can find the article number of
the premounted pawl on the back page of these instructions for use. The length is lasered
onto the pawl. The higher the last three digits of the article number are, the longer the
pawl is (fig. 37). The step lock pawl and step lock stop disc must always be exchanged
together.

12.4 Cleaning

The system joint must be cleaned when necessary and during regular maintenance. For this purpose, disassem-
ble the system joint and clean the soiled system components with a dry cloth.
Repair Repair
Bushing Bushing
Inner Ø Outer Ø
7.0 8.0
8.5 9.6
9.6 10.5
10.5 11.5
0.45mm 0.50mm
Ø Measure- Ø Measure-
ment for ment for
Boring Reaming
7.7 8.0 H7
9.3 9.6 H7
10.2 10.5 H7
11.2 11.5 H7
0.55mm
Art. No.
Repair Bushing
BP0807-L056
BP1009-L065
BP1110-L078
BP1211-L090
0.60mm
fig. 36
fig. 37
43