Miele PW 6163 Notice De Montage page 9

Produktgruppe 512
9 von 36
en
Parts required
Quantity Mat. no.
1 07285400
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist training,
knowledge and experience, and recent related work experience) in accordance with all appropriate local and national
safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance
with all appropriate legal requirements, accident prevention regulations and valid standards. All regulations of the
appropriate utility supply companies and standards relating to safety (not limited to electrical safety) are to be complied
with.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable measurements must
be made to ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire.
Danger!
Correct earthing function can be deactivated if casing parts are incorrectly assembled.
Correct earthing function must be ensured when refitting the casing.
Carry out appropriate electrical safety checks.
Note
The kit, Mat. no. 07285400, for PW 6163, PW 6243 and PW 6323, contains the following:
1 electronic module EZL 230-A, module 2 (liquid dispensing 7 - 12)
1 electronic module holder
1 coding plug MFM 2-5 (EZL 230-A - 42X), pin 2-5
1 adapter EV 230
8 spacers
1 wiring harness 48X-41X (EZL 230-A - 48X / EZL 230-A - 41X), plug housing, 3-pole, 110 mm
1 wiring harness 49X-46X (EZL 230-A - 49X / EZL 230-A - 46X), plug housing, 7-pole, 110 mm
1 wiring harness 47X-100X (EZL 230-A - 47X / EV 230 - 110X), plug housing, 7-pole, 1820 mm
1 wiring harness 51X-52X-101X (EZL 230-A - 51X-52X / EV 230 - 111X), plug housing, 8-3-pole, 2600 mm
1 connection wire - Green-yellow 0.75 x 400
3 captive nuts M4
3 bolts M4 x 12.5
1 liquid dispensing module (7 - 12)
1 wiring diagram for multifunction module 2 dispensing 2 (pumps 7 - 12) and peak-load cut-out control,
Mat. no. 07033903
Fitting instructions - Module 2, liquid dispensing 7 - 12 - Clean/Soiled side, Mat. no. 07523811.
09.06.2010 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Conversion kit MF02-RU multifunction module - Clean/Soiled side
M.-Nr. 07523811