Lubrication - Techness RUN 800 Manuel D'utilisation

TREADMILL MAINTENANCE
Proper maintenance is very important to ensure a faultless and operational condition of the
treadmill. Improper maintenance can cause damage to the treadmill or shorten the life of the
product.
All parts of the treadmill must be checked and tightened regularly. Worn out parts must be
replaced immediately.

1. LUBRICATION

The treadmill is factory-lubricated. However, it is recommended to check the lubrication of the
treadmill regularly, to ensure an optimal operation of the treadmill. It is usually not necessary to
lubricate the treadmill in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the belt, as
far as possible. If traces of silicon spray are found, lubrication is not necessary.
In case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
2. Application of lubricant on the belt:
● Position the belt so that the seam is located in the middle of the plate.
● Insert the spray valve in the spray head of the lubricant container.
● Lift the belt at one side and hold the spray valve in a distance to the front end of striding belt
and plate. Start at the front end of the belt. Lead the spray valve in direction of the back end.
Repeat this process on the other side of the belt. Spray each side for about 4 seconds.
● Wait 1 minute to let the silicon spray spread, before starting the machine.