Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Step 1: Take the machine
out of
package，put on
a flat
surface；Use 10pcs M8*20 separately to
fit
the stand post (Left and right)
onto
the base frame.
Please do not tight any bolts till 10pcs
screws all fit into the punch holes (Before
assembling the right stand post, please connect the
signal wire
from
the base frame
to
the stand post)
Step 2: Connect the handle pulse wire
in
right
hand
post with the signal wire/handle pulse wire
from the computer, then use 4pcs screw(M 8*20) to
fit
the computer
onto
the stand post.
Don't
tighten bolts until all screws fit into the hole. Be careful not to damage wire while tightening bolts.
Publicité
Table des Matières
