Techness RUN 800 Manuel D'utilisation page 83

Electricity is too high: When the
treadmill is running, the controller
test there is big electricity than
the standard electricity +6A, last
3seconds.
E5
E6 Voltage is not correct
E9 Incline failure
The treadmill can't work and not switch on.
Computer show E5, other places no
showing and cause warning sound 9 times.
Stop the treadmill, if it return to the normal
appearance, it can start again.
Cause：The electricity is too high than the
standard, there is a self-protect. Or there is
something stucking somewhere, so the
motor can't work. Restart the treadmill.
Besides, check if there is noise and burnt
smell when running, and then change the
motor. Or check the controller, if there is
burnt smell, change the controller. Or
check the voltage is standard or not , use
the right voltage to test again.
The treadmill can't work and not switch on.
Computer show E5, other places no
showing and cause warning sound 9 times.
Stop the treadmill, if it return to the normal
appearance, it can start again..
Cause: check the voltage is lower than
50% of the standard voltage. Use the
correct voltage to test again. Check
whether there is some smell in the
controller, and then change the controller.
Check the wiring of the motor.
Check the incline motor wiring and the
plug. Check the AC wiring of the incline
motor. Check the wiring of the motor. After
check, Press the incline button on the
control board, Self-test can be completed
then can use again.