Specifications - VOLTCRAFT VBM-100 Notice D'emploi

Error
The meter cannot
be switched on.
Measuring results are
faulty.
Meter cannot be
controlled.
Any repair work other than that described above must be carried out by an approved spe-
cialist.
If you have questions concerning the use of the meter, our technical support service is
available at the following telephone number:
Voltcraft, Lindenweg 15, 92242 Hirschau, tel. no. 0180 / 586 582 7

Specifications

Display..................................................LC display with bargraph
Sensor measuring frequency................10 Hz – 1 kHz (sensitivity according to ISO 2954)
Battery ..................................................1x 9V (PP3) battery (006P, MN1604)
Power input ..........................................approx. 13 mA
Operating temperature ........................0 to + 50°C
Relative humidity ..................................< 80%rF, non-condensing
Weight ..................................................Device approx. 253 g, sensor approx. 99 g
Dimensions (L x W x H mm) ................200 x 68 x 30 (device)
(∅ x L mm) ..........................................16 x 37 (sensor)
Sensor cable length..............................approx. 1.2 m
Measuring tolerances
Accuracy at 80 and 160 Hz in ± (% of readout + display errors in counts (= number of smallest points)).
The accuracy is valid for one year at a temperature of +23°C (± 5°C) with relative humidity less than
80 %rF, non-condensing.
Possible cause
Is the battery dead?
Faulty measurement?
Is the sensor positioned flat
on the surface?
The HOLD function is activated
("H" is displayed)
Undefined system status
Remedy
Check the battery status.
Remove the battery and insert it
again (reset device).
Check the flatness of the meter
on the measured surface.
If necessary, use the provided
screw-on magnet.
If necessary, null balance the device.
Deactivate the hold function by
pressing the "HOLD" button (3).
Remove the battery and insert it
again (reset device).
29