Cleaning The Shower Head Faceplate; Replacing The Filters; Replacing The Solenoid Valve Cartridge - Franke AQCT0073 Notice De Montage Et De Mise En Service

24. Cleaning the shower head faceplate

☞
The shower head faceplate should be cleaned every month.
Warning!
Wear eye protection and protective gloves when handling chemicals.
Caution!
Use a decalcifier based on citric acid.
24.1 Spray the shower head faceplate with a decalcifier.
24.2 Allow the decalcifier to act. Note the information on the decalcifier packaging.
24.3 Clean the shower head faceplate with a cloth or a soft brush.
24.4 Rinse the shower head faceplate with plenty of water.

25. Replacing the filters

Water volume regulator filters
25.1 Remove the shower panel (see
25.2 Unscrew the locking screws (a) on the water volume regulators.
25.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
25.4 Reassemble in reverse order.
Solenoid valve cartridge filter
25.5 Remove the solenoid valve cartridge (see
25.6 Use flat-nosed pliers to remove the filter (c).
25.7 Replace the filter.
☞
Important!
Note the installation position. The crosspiece of the filter may not be on top of the
flow hole.
25.8 Reassemble in reverse order.

26. Replacing the solenoid valve cartridge

26.1 Remove the shower panel (see
26.2 Loosen the cable connection between the solenoid valve cartridge and the
electronics module.
26.3 Loosen the screws (a).
26.4 Remove and replace the solenoid valve cartridge (b).
26.5 Reassemble in reverse order.
Chapter 22.).
Chapter
Chapter 22.).
- 15 -
26.).