Operation - Bartscher 200240 Mode D'emploi

•
Do not place the device near an open flame, electric heater or other heat source.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect
the device if the need arises.

5.3 Operation

o Before commencement of device usage, it needs to be cleaned (item 6.2 „Cleaning").
o Fill container with water up to level marked as „MIN".
CAUTION!
Always make sure that the water level does not fall below the „MIN" mark!
This needs to be inspected periodically during use!
Never use the device without water in the container!
NOTE!
Pour warm water into the device, this will save time and energy!
•
Connect plug into appropriate socket. When the ON/OFF switch is moved to the „I"
position, the red indicator diode will light up.
•
Temperature adjustment for the device is effected using the temperature adjustment
knob. Settings 1 – 5 correspond to the following temperature levels:
level 1 – 40 ° C
level 2 – 50° C
level 3 – 60 ° C
level 4 – 70 ° C
level 5 – 90 ° C
- 21 -