Installation And Operation; Safety Instructions - Bartscher T 7L Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
•
Never turn off or remove the safety devices from the appliance.
•
Keep stiff objects away from the mixing bowl and from the mixing tools during
operation of the device.
WARNING!
To avoid injuries and/or damages of the device keep hands, hair and clothes as
well as spatulas or similar utensils away from the mixing bowl and from the
mixing tools during operation of the device.
•
Do not leave the device unattended during operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
- 26 -
All manuals and user guides at all-guides.com