AGV K6 Manuel D'utilisation page 9

4 THE VISOR
K6 helmet visor is made of scratch-resistant polycarbonate and it is equipped with a
mechanism which allows the visor to lift and remain open at 5 different stages.
The locking mechanism is centralised and, as well as guaranteeing the visor has a
tight seal while riding, reduces the chances that it opens in case of fall, thus prevent-
ing any foreign bodies from coming into contact with the user's head.
4.1 WORKING POSITIONS
1. Visor closed.
2. Visor in micro-opening position in
order to allow a moderate air flow
while riding at low speed.
3. Visor at first intermediate opening
position.
4. Visor at second intermediate open-
ing position.
5. Visor in full opened position.
Warning! While riding it's always
advisable to proceed with the visor
completely closed, in position 1.
Warning! In case of prolonged in-
activity, we recommend leaving the
visor in a micro-opening position,
in position 2.
4.2 MICRO-OPENING
Condition: the visor is opened.
Lower the visor (1) until the plastic
•
hook (2) gets wedged into the open-
ing button (3) at the first click.
→ The visor is now settled in mi-
cro-opening position, at about 10 mm
of distance from the chin guard.
Warning! If necessary, ease the
joint slightly pressing the opening
button (2).
Condition: the visor is closed.
Press the opening button (3) and, in
•
a single gesture, push the visor edge
(1) upwards until the plastic hook (2)
engages the opening button.
→ The visor is now settled in mi-
cro-opening position, at about 10 mm
of distance from the chin guard.
14
EN
4.3 REMOVAL
Condition: the visor is in full opened position.
Start the operation on the right side of the
mechanism.
•
•
→ Now the visor is released and
5
4
3
4.4 INSTALLATION
Condition: start the operation on the right
2
side of the visor mechanism.
1
• Turn the metal movement guide
•
•
→ The visor is now fastened. Check the
4.5 CLEANING
For an optimal cleaning, remove the visor from the helmet and clean it using a soft
1
cloth moistened with lukewarm water: if the visor is very dirty, add some neutral soap
to the water.
2
Rinse the visor under running water and dry it by dabbing it with a soft cloth. Do not dry
3
by rubbing.
Pull downwards the spring release
lever (1; arrow) and move the visor
away (2) from the shell.
Repeat the same operation on the
left side of the visor mechanism.
removable.
(1) so it is oriented in full opening
position.
Place the visor (2) on the fasten-
ing mechanism and, activating the
spring hooking lever (3), close the
visor in the correct position.
Repeat the previous operations on
the left side of the visor mechanism.
correct rotation in the different posi-
tions (see paragraph 4.1).
Notice! The cleaning is easier and more effective when it's immediately done
after the usage.
Warning! Never use petrol, benzene, glass cleaners, abrasive products or
chemical solvents, as they may compromise the visor properties. Do not use
sharp or pointed objects to remove sedimented dirt from the visor. Do not dry
the visor on heat sources.
1 2
1 2 3
15
EN