lopital Reflex 5100 5600 Mode D'emploi page 41

Make sure you push the plug into the correct position
in the charging point.
Only the original charger for the Reflex may be used.
If you use another charger, Lopital cannot be held
liable for any consequences, such as damage to the
electronics.
Once the charger is connected to the Reflex, the
controls will go into 'sleep' setting (all functions are switched off).
The charger that must be used for the Reflex is the 'Mascot 2241'.
• When the indicator LED on the charger turns green, the battery is charged. The char-
ger can remain connected even when the battery is completely charged. Leaving it
connected will not cause any damage.
• Disconnect the Reflex from the charger.
• Once activated, the Reflex is now ready for use (See paragraph 2.2. Activating).
LEDs not on: Chair is in 'sleep' setting and cannot be used.
Green LED is on: Chair is ready for use
Red LED blinks: Battery must be charged (chair can still
be used).
Red LED on: Battery is completely empty and must
be charged immediately
Charge battery in a well-ventilated, dry space.
After using the chair, connect it to the charger to main-
tain the battery. Charge the chair at least once a week!
For instruction videos go to www.lopital.com or www.youtube.com/user/LopitalNL
Reflex Shower-toilet chair | Instructions for use | 41
2
1
Figure 26 Charging point.
Figure 27 Battery indication on
control panel.