lopital Reflex 5100 5600 Mode D'emploi page 35

• The carer or the client first raises one leg; the carer then folds the footrest down
(See figure 5). The same procedure is then carried out with the other leg. Make sure
that the footrests are set to the right height.
• The footrest height is adjustable in steps over 23 cm / 9 inch (Minimum 26.5 cm /
10.4 inch and maximum 50 cm / 19.7 inch, measured from the top of the seat to the
upper side of the footrests).
Figure 6 Folding up footrests.
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.
Footrests on Reflex with Flexo footrests (Article number chair 5100 5605).
• Before the client takes a seat in the Reflex, the footrests must be folded upwards.
This will ensure there is sufficient space for the person to easily take a seat in the
chair (See figure 6). If more room is required, the Flexo footrests can be turned out
(See figure 7). First, the footrests must be slightly raised (1) and then they can be
turned outwards (2).
• The carer or the client first raises one leg; the carer then folds the footrest down
(See figure 8). The same procedure is then carried out with the other leg.
Always replace this component on the chair when you have finished using it.
This will avoid the component being lost.
1
Figure 7 Turning out footrests.
Reflex Shower-toilet chair | Instructions for use | 35
2
Figure 8 Folding down foot rests.