lopital Reflex 5100 5600 Mode D'emploi page 36

Option: Comfort leg support (Article number 6960 8026).
This option is only possible with the 5100 5605.
The comfort leg supports provide the legs with additional support. The comfort leg sup-
ports can be adjusted in length as well as according to the sitting angle. The angle of
the leg supports can be adjusted to 4 positions (See figure 9 to 12). To change the sea-
ting angle, you have to release the locking pin. When you have determined the correct
position, lock the sitting angle of the comfort support once again (See figure 13).
Make sure that the locking pin slips in well into one of the 4 holes.
Figure 9 to 12 Adjustable seating angle.
Figure 13 Locking pins.
To adjust the length of the leg support, you have to release the locking pin underneath
by loosen it a bit (See figure 13). Choose the right length for the leg support and tighten
the locking pin again.
Make sure that both the sitting angle and the length of the leg support are
locked properly as soon as they have to support a load.
36 | Instructions for use | Reflex Shower-toilet chair
Setting the angle of the locking pin
Setting the length of the locking pin