O.tilt-In-Space Mechanism; Stroller Handle Extension; Q.reclining Back; Check-Out - Quickie SR45 Mode D'emploi

SR4 5
O. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger mechanisms positively lock the chair in
place from 0º to 45º depending on the set-up.
21
1. Trigger Tilt Operation
a. Depressing both triggers (A) at the same time disengages the locking mechanism and allows the seat and
back to rotate in space. Releasing the triggers positively locks the rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (C).
c. To lock out the tilting function, and prevent accidental tilt, be sure to insert the locking pins (B) into the
trigger holders when you are done adjusting the tilt.
22
2. Foot Release
a. Depressing foot pedal (D) disengages the locking mechanism and allows the seat and back to rotate in
space. Releasing the foot pedal positively locks the rockers in place.
b. The approximate degree of tilt the seat is at can be seen on the tilt indicator (C).
P. STROLLER HANDLE EXTENSION (option)
Installation
a. Press button (E) on the stroller handle so that release pins are drawn inside the tube.
b. Insert the tube into the back tube receiver (F) until the release pin protrudes through the receiver
mounting hole.
Q. RECLINING BACK
The dual trigger reclining mechanism is installed by Sunrise.
To Recline or Raise Backrest
a. Depress both triggers (G) at the same time. Releasing the triggers positively locks the backrest in place
within its 45° range.
b. To lock out the adjustment system, insert the locking pin (H) into the trigger holder.
NOTE– ALWAYS lock the dual trigger reclining mechanism securely in place after positioning the backrest.
R. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review assembly and adjustment sections to make sure the chair was properly prepared.
2. Review the troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting
your authorized supplier, contact Sunrise customer service. See the introduction page located in the
front of this User's Manual for details on how to contact your authorized supplier, or Sunrise customer
service.
23 24
17
VIII. USE AND MAINTENANCE
G
H
22
23
F
E
24
118611 Rev. C