Q.attendant Wheel Lock Installation - Quickie SR45 Mode D'emploi

SR4 5
Q. ATTENDANT WHEEL LOCK INSTALLATION
1. Remove wheels from chair.
2. Attach Mount bracket/cable assembly to axle strut tube using 1/4" x 2" bolt (item 1) with nut and wash-
ers.
3. If push-to-lock wheel locks are already installed, remove the push-to-lock assemblies by loosening slide
adjusting screws and sliding the wheel lock assembly out of the clamp. Leave the clamp in place, and skip
to step 5. If there are no wheel locks mounted already, proceed with step 4.
4. Attach Wheel Lock clamps (Item 9) to roller assembly in the desired location on each side of the chair
using 5/16" hex bolts (Item 2).
5. Attach the left and right Remote Lock Assemblies (item 4) to the slide bars using the Attendant Wheel
Lock Spacer Blocks (item 3), M6 x 60 screws (item 6), lock nuts (item 5), and flat washers (item 7).
Smaller wheels will need to have the slide bar oriented forward: larger wheels need the slide bar oriented
rearward. Tighten bolts. Slide the lock assemblies into the wheel lock clamps.
6. Re-install wheels and slide the remote lock assemblies rearward until the friction block of the remote
lock is approximately 1/4" (6mm) away from the tire when unlocked. If the lock cannot be adjusted to
this position, you will need to adjust the position of the wheel lock clamp until it can be adjusted as stat-
ed. Once locks are properly positioned, tighten clamp bolts (item 8).
7. Attach cables to remote lock assemblies by sliding the stud at the end of the cable into the slot in the
remote lock assembly. Pull back on the cable sheath and slide the end of the cable sheath into the pocket
on the attendant wheel lock spacer block (item 3) as shown. Be sure that the cables are routed away
from all moving parts. Attach the cables into place on the chair with zip-ties provided. If not already
equipped, axles with spacers will need to be used on the rear wheels.
8. Adjust the cable adjustment screws (item 10) as necessary to ensure that the wheel locks can get to
their fully extended position when the pedal is engaged. Position of the remote lock assembly may need
to be fine tuned to optimize the force needed to engage the pedal, depending on tire type. If excessive
force is needed to engage the pedal, cable life may be reduced. Once proper adjustment is attained, lock
cable adjustment screw in position by tightening jam nuts against mounting block.
IX. DEALER SERVICE & ADJUSTMENT
50 51
25
Rearward
50
51
Forward
118611 Rev. C