H.footplate Adapter Bracket; Elevating /Articulating Legrest - Quickie SR45 Mode D'emploi

SR4 5
H. FOOTPLATE ADAPTER BRACKET
The footplate adapter bracket(A) can be installed by the dealer. The main purpose of this part is to allow for
height adjustment while using front mount footplates on a quick release hanger. The plate can be reversed which
adds to it's range of adjustment.
1. Footplate Height Adjustment
a. Remove the hardware (B, C) and remove the footplate(D) and adapter plate assembly.
b. Move the footplate(D) and assembly up or down to the desired position, using the "Front mount hanger
setup" table, and (figure 32) as reference.
c. Re-insert and tighten the hardware (B, C) to a torque of (96in-lbs)
d. Repeat the process for the other hanger and footplate.
NOTE– In most cases you will want to make sure the footplates are adjusted so that the height is the same on
both sides
I. ELEVATING / ARTICULATING LEGREST
1. Height Adjustment of the Calf Pad
a. Loosen the retaining nut (G) located at the back of the calf pad bracket assembly.
b. Slide the calf pad bracket assembly up or down.
c. Tighten the retaining nut (G once the pad is in the desired position.
Height Adjustment with Extension Tube
a. (See "Swing-away Height Adjustment" Section G)
118611 Rev. C
30 31 32
33
20
IX. DEALER SERVICE & ADJUSTMENT
30
31
32
ADAPTER
2" EXTENSION
4" EXTENSION
33