Wheel Locks; Single-Post Armrest Receiver; G.swing-Away Height Adjustment - Quickie SR45 Mode D'emploi

SR4 5
4. Axle Height Adjustment
a. Loosen and remove bolts (E).
b. Set axle at desired height using pre-set holes in the axle plate (B) on both sides.
c. Replace and tighten bolts.
27
E. WHEEL LOCKS
Adjustment
a. Evenly loosen both screws (A). Do not attempt to remove one screw at a time.
b. Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement, when in
locked position.
c. Tighten screws (A).
F. SINGLE -POST ARMREST RECEIVER
1. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the bolts on the sides of the receiver (D).
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts (D).
2. Moving the Receiver location
a. Loosen the 3 bolts (C) holding the clamp halves(B) together (do not remove them)
b. Slide the clamp so that armrest is at the correct position.
c. Tighten the 3 bolts (C).
G. SWING-AWAY HEIGHT ADJUSTMENT
Height Adjustment
NOTE– It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (E) using a 3/16 inch hex key.
b. Slide footrest extension (F) up or down inside frame tube to desired height.
c. Tighten set screw (E). Use a torque setting of 144 in-lbs (16.27 Nm).
26
28
29
IX. DEALER SERVICE & ADJUSTMENT
19
27
A
28
C
B
D
29
E
118611 Rev. C