Residual Risks; Know Your Product - Ryobi EMS305RG Traduction Des Instructions Originales

Do not use optical tools to view the laser beam.
Do not operate the laser around children or allow
children to operate the laser.
Do not attempt to repair the laser device by yourself.
Do not attempt to change any parts of the laser device
by yourself.
Any repairs must only be carried out by the laser
manufacturer or authorised service agent.
Do not replace the laser with a different type.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
Risk of contact with uncovered parts of the rotating saw
blade
Kick-back of workpieces or parts of workpieces due to
improper adjustment or handling
Catapulting of faulty carbide tips from the saw blade
Damage to the respiratory system
NOTE: Wear respiratory protection masks containing
filters appropriate to the materials being worked.
Ensure adequate workplace ventilation. Do not eat,
drink or smoke in the work area.
Damage to hearing if effective hearing protection is not
worn.
WARNING
Dust from certain paints, coatings and materials may
cause irritation or allergic reactions to the respiratory
system. Dust from wood such as oak, beech, MDF and
others are carcinogenic. Material containing asbestos
specialist operators.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 222 - 223.
1. Handle, insulated gripping surface
2. Power switch
3. Safety lock handle
4. Upper guard
5. Saw blade
Lower guard
7. Clamp
8. Main fence
9. Turntable
10. Base
11. Table insert
12. Turntable lock handle
13. Balancing foot
14. Laser switch
15. LED switch
Bracket stop
17. Lower guard cover
18. Sliding fence
19. Mounting hole
20.
21. Screws for adjusting the bevel angle limit stop
22. Spindle lock knob
23. Top handle
24. Dust bag
25. Cutting depth adjustment knob
Linear rod stop knob
27. Winding support
28. Bevel angle lock knob
29.
30. Screws for adjusting mitre angle
OPERATION
The product features a moving saw blade that can be set at
various angles by the operator when cutting a work piece
be operated by only one person to prevent unintentional
contact with the moving saw blade.
The principles for safe operation of the product are as
follows:
Maintain saw, blades and work area in good condition.
Secure the mitre saw base to a sturdy work bench.
The product may move and tip if it is not adequately
secured.
Set up and lock the cutting angles and depth before
making the cut.
Secure the work piece to the mitre saw base. Use the
clamp provided and, where necessary, use additional
clamps or holding mechanisms to prevent unintentional
movement of the work piece while cutting.
Check that the operation of the blade guards are not
restricted by the position of the work piece.
Ensure that the fence and other parts of the product
will not be cut as the blade lowers to the cutting
position.
Start the motor and allow the blade to reach full speed
before slowly lowering it to cut the work piece. Slide
complete the cut as necessary.
Allow the blade assembly to rise to its upper position
where the blade guards are fully closed. Switch off the
motor and allow the blade to come to a complete stop
before removing the work piece or off-cuts, or before
reaching into the area of the blade.
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
5