grandimpianti AS 27 Mode D'emploi page 25

www.groupdynamics-laundry.com
sales@groupdynamics.lv
7-3) Alarm E3: Drain alarm.
Water has failed to drain below the safety level after one minute. The cycle will be resumed after
water has reached below the safety level, with no effect on cycle completion. The buzzer is not
actuated. As for the causes, see alarm E1.
7-4) Alarm E4: Heating alarm
After the heating has worked for 20 minutes, the temperature has not risen by at least 5°C, and
yet the cycle proceeds normally. This alarm will automatically disappear as soon as the
temperature reaches the established threshold. The buzzer is not actuated. The cause may be an
incorrect connection of the heating elements or either scale or lint on the heating elements. It is
advisable to check that the hot water inlet has been connected properly: if the cold and hot water
inlets have been inverted, heating times will be abnormally increased.
7-5) Alarm E5: Overtemperature alarm - disconnected temperature probe
Water temperature has exceeded 95°C or the temperature probe is either broken or disconnected.
The wash cycle is aborted and the buzzer is activated. This alarm can be cancelled only by
switching the machine off and then on again.
7-6) Alarm E6: Door lock alarm
Ten seconds after cycle start the door has failed to be locked (i.e. the door is not closed ten
seconds after the START key has been pressed). The wash cycle is aborted and the alarm status
can be removed only by pressing the "START" key again. The buzzer is not activated. Possible
causes: the door may not be closed properly or the door microswitch may be damaged owing to
handle misuse.
7-7) Alarm E7: Door alarm
Door damage is detected during operation: the wash cycle is immediately aborted and the tub is
drained. Normal operation may be resumed only by switching the machine off and then on again.
The buzzer is actuated.
7-8) Alarm E8: Level alarm
A water level 10 cm above the established height is detected: the cycle is aborted and the buzzer
is actuated. To remove this alarm, just switch the machine off and then on again. The cause of
this alarm is surely the level probe. ATTENTION, this fault can also be caused by the use of
foamy soap.
7-9) Tilt alarm E9
When this alarm status occurs, the step in progress is aborted but the cycle is not cancelled. The
motor is disenergised for 200 or 90 seconds for high-speed spin and low-speed spin respectively.
Then a distribution step intervenes for 90 seconds in order for the laundry to be spread correctly.
Alarms occurring during intermediate spin are not displayed: after distribution, the cycle skips
the spinning step and proceeds. Conversely, alarms intervening during final spin blink E9: after
distribution, the machine makes further spinning attempts, up to a maximum of 15 and if it still
fails to spin, the alarm sign E9 is lit continuously, the buzzer is actuated and the cycle is aborted.
To remove this alarm it will be necessary to switch the machine off and then on again.
Alarm causes may be an incorrect laundry load (too little or too big), unlevel machine
positioning or dampers worn out through repeated incorrect loads.
7-10) Motor overload cutout E0
Page 25/36 utilisation d1500 fr-EN.1 par PS le 08/04/2005