grandimpianti AS 27 Mode D'emploi page 24

www.groupdynamics-laundry.com
sales@groupdynamics.lv
- turn the machine off by the main switch
- close the hot water, cold water and steam taps (the latter applies to steam-heated machines
only).
- turn the wall cutoff switch off.
5 WASH PROGRAMS
Cycle steps are detailed in the user-friendly tables attached.
6 WARNING
- Do not leave the machine on to no purpose. TURN the main switch OFF when the machine is
not used.
During use:
- Open the door only when the drum is still and drained.
- In case of a potential drop, open the door by the manual puller, down on the left.
Before opening the door make sure that the drum has come to a complete halt, that the water has
been drained and the temperature is lower than 40°C.
- Before any maintenance or cleaning operation, check that the wall cutoff switch is off and the
hot water, cold water and steam taps are closed (the latter applies to steam-heated machines
only).
- Do not load the drum with fabrics that have been cleaned, dampened, washed or stained with
inflammable or explosive substances. Otherwise, hand-wash them first.
- Keep inflammable liquids far from the washing machine, in dry and ventilated premises, out of
the reach of outsiders.
- Keep cleaning products and washing powders far from the machine, if possible, closed in a
cabinet.
- Do not hamper air inlets or heat-exchanging openings. Keep an appropriate distance between
the machine and the walls or other objects.
7 ALARMS
7-1) Alarm E1: water in the tub.
If water in the tub is detected before the start of a cycle, all functions are disabled. The alarm will
disappear as soon as water reaches below the safety level. This alarm does not involve buzzer
actuation and will be removed by simply switching the machine off and then on again. The
sources of this fault are either the drain (make sure that the solenoid valve is clean and in good
working order) or the built-in level pressure switch.
7-2) Alarm E2: Water level alarm
The water level required by the specific program has not been reached after taking in water for 5
minutes. This alarm signal will automatically disappear as soon as the tub receives the required
amount of water. This alarm has no effect on the cycle, which is resumed as soon as the correct
water level is reached.
If the correct level fails to be reached after water has been taken in for 10 more minutes the cycle
is stopped and the buzzer is activated. To remove this alarm, just switch the machine off and then
on again. The causes may be poor pressure in the mains, a blocked filter in the water intake
solenoid, a closed supply tap, a broken drain solenoid valve or a leak in the same (water is taken
in but it is simultaneously drained and it consequently fails or is slow to reach the required
level).
Page 24/36 utilisation d1500 fr-EN.1 par PS le 08/04/2005