When Not In Use - GE WSLP1500 Manuel D'utilisation Et D'installation

WHEN USING THE WASHER
■
Never reach into washer while it is moving.
Wait until the machine has completely stopped
before opening the door.
Use this
■
Do not mix chlorine bleach with ammonia
appliance
or acids such as vinegar and/or rust remover.
only for its
Mixing different chemicals can produce a toxic
intended
gas which may cause death.
purpose as
■
Do not wash or dry articles that have been
described in
cleaned in, washed in, soaked in or spotted
this Owner's
with combustible or explosive substances (such as
Manual.
wax, oil, paint, gasoline, degreasers, dry-cleaning
solvents, kerosene, etc.) which may ignite or
explode. Do not add these substances to the
wash water. Do not use or place these substances
around your washer or dryer during operation.
■
The laundry process can reduce the flame
retardancy of fabrics. To avoid such a result,
carefully follow the garment manufacturer's
wash and care instructions.

WHEN NOT IN USE

■
Turn off water faucets to relieve pressure on
hoses and valves and to minimize leakage if
a break or rupture should occur. Check the
condition of the fill hoses; GE recommends
changing the hoses every 5 years.
■
Before discarding a washer, or removing it
from service, remove the washer door to prevent
children from hiding inside.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
■
To minimize the possibility of electric shock,
unplug this appliance from the power supply
or disconnect the washer at the building's
distribution panel by removing the fuse or
switching off the circuit breaker before attempting
any maintenance or cleaning. NOTE: Pressing the
power button does NOT disconnect the appliance
from the power supply.
■
Never attempt to operate this appliance
if it is damaged, malfunctioning, partially
disassembled, or has missing or broken parts,
including a damaged cord or plug.
■
Do not attempt to repair or replace any part of
this appliance unless specifically recommended
in this Owner's Manual, or in published user-repair
instructions that you understand and have the
skills to carry out.
■
Do not tamper with controls.
ge.com
3