When Not In Use; Controls - GE Profile WPRB9110D1CC Manuel Du Propriétaire

WHEN USING THE WASHER
I
Never reach into washer while it is moving.
Wait until the machine has completely stopped
before opening the lid.
I
Do not mix chlorine bleach with ammonia or
Use this
acids such as vinegar and/or rust remover.
appliance
Mixing different chemicals can produce a toxic
only for its
gas which may cause death.
intended
purpose as
I
Do not wash or dry articles that have been
described in
cleaned in, washed in, soaked in, or spotted with
this Owner's
combustible or explosive substances (such as wax,
Manual.
oil, paint, gasoline, degreasers, dry-cleaning
solvents, kerosene, etc.) which may ignite or
explode. Do not add these substances to the wash
water. Do not use or place these substances around
your washer or dryer during operation.

WHEN NOT IN USE

I
Turn off water faucets to relieve pressure on
hoses and valves and to minimize leakage if
a break or rupture should occur. Check the
condition of the fill hoses; they should be
replaced every 5 years.
I
Before discarding a washer, or removing it
from service, remove the washer lid to prevent
children from hiding inside.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
I
The laundry process can reduce the flame
retardancy of fabrics. To avoid such a result,
carefully follow the garment manufacturer's wash
and care instructions.
I
To minimize the possibility of electric shock,
unplug this appliance from the power supply
or disconnect the washer at the household
distribution panel by removing the fuse or
switching off the circuit breaker before attempting
any maintenance or cleaning. NOTE: Pressing
START or STOP does NOT disconnect the
appliance from the power supply.
I
Never attempt to operate this appliance if it is
damaged, malfunctioning, partially disassembled,
or has missing or broken parts, including a
damaged cord or plug.
I
Do not attempt to repair or replace any part of
this appliance unless specifically recommended
in this Owner's Manual, or in published user-
repair instructions that you understand and have
the skills to carry out.
I
Do not tamper with controls.
ge.com
3