Possible Causes - GE WSLP1500 Manuel D'utilisation Et D'installation

Before you call for service...
Troubleshooting Tips
WATER
Too many suds
Water leaks
Water temperature
is incorrect
Water won't drain
18

POSSIBLE CAUSES

Type of detergent
Very soft water
Too much detergent
Fill hoses or drain hose is
improperly connected
Household drain may
be clogged
Constant water pressure
to the fill hoses at the
water source
Using too much detergent
in washer
Water supply is turned off
or improperly connected
Water valve screens are
stopped up
House water heater is
not set properly
Drain hose is kinked or
improperly connected
WHAT TO DO
• Switch to HE detergent.
• Try less detergent.
• Measure your detergent carefully. Use less soap if you
have soft water, a smaller load or a lightly soiled load.
• Make sure hose connections are tight at faucets and the
washing machine. Make sure the end of the drain hose
is correctly inserted and secured to the drain.
• Check household plumbing. You may need to call
a plumber.
• Tighten hoses at the faucets and turn the water off
after each use.
• Check condition of the fill hoses; they may need
replacement after 5 years.
• Use less detergent. Use less soap if you have soft water,
a smaller load or a lightly soiled load.
• Turn both hot and cold faucets fully on and make sure
hoses are connected to correct faucets.
• Turn off the water source and remove the water
connection hoses from the upper back of the washer.
Remove screens and use a brush or toothpick to clean the
screens in the machine. Reinstall screens, reconnect the
hoses and turn the water back on.
• Make sure house water heater is delivering water
at 120°F–140°F (48°C–60°C).
• Straighten drain hose and make sure washer is not
sitting on it.
• Top of drain outlet should be less than 8 ft. above floor.