Washer Connections For Stationary Model - GE WSLP1500 Manuel D'utilisation Et D'installation

WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500
WARNING:
1 FLUSH WATER LINES
Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.
CONNECT TO WATER LINES
2
Connect the inlet hose ends to the HOT and COLD water
faucets tightly by hand, then tighten another
pliers. Turn the water on and check for leaks.
3 CAREFULLY MOVE THE WASHER TO
ITS FINAL LOCATION
Installation Instructions
Make sure the washer is unplugged.
2 ⁄ turn with
3
4 CONNECT DRAIN HOSE
Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose in
a laundry tub or stand pipe and secure it with a cable
tie (not included).
NOTE: If the drain hose is placed in a stand pipe without
forming a U shape, a siphoning action could occur. There
must be an air gap around the drain hose. A snug hose
fit can also cause a siphoning action.
Laundry Tub
Cable Tie
Stand Pipe
PLUG THE POWER CORD INTO A
5
GROUNDED OUTLET
Insure proper ground
exists before use
Cable Tie
Cable Tie
11