Use And Maintenance (User Part); Warnings; Description Of The Warning Panel; Managing The Unit With The Remote Control - Unico Digitemp Manuel D'installation, Emploi Et Entretien

3
3
3.1

WARNINGS

The installation and electrical connection of the air conditioner should be carried out by specialized personnel who
possess the requisites set forth by law. The installation instructions are contained in the appropriate paragraph of
this manual.
No structural object (furniture, curtains, plants, leaves, blinds, etc.) should ever obstruct the normal flow of air from
either the internal or external gratings.
Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious damage to the external
parts.
Do not move the air outlet flap by hand. Always use the remote control to adjust baffle position.
If the unit leaks water, switch it off immediately and disconnect it from the power mains. Call the nearest service centre.
When the air conditioner is heating, it has to periodically eliminate any ice that could form on the external battery.
While it is doing this, the machine keeps running but does not heat the room. This lasts for a brief period of time,
from 3 to a maximum of 10 minutes.
The air conditioner must not be installed in rooms where explosive gasses develop or where there are conditions
of heat and humidity beyond the maximum limits indicated in the installation manual.
Clean the air filter periodically, as described in the specific paragraph.
3.1.1 Description of the warning panel (fig. 22)
G) Transparent area in which the signal is received from the remote control.
LED D) Green LED that indicates the machine is running (when the machine is in standby this light is off).
LED C) Yellow LED signals activation of the programming switch on and/or switch off.
LED B) Green LED that indicates the switching on of the cooling compressor.
LED A) Red LED that indicates the air filter must be cleaned.
H) Service micro-button (RESET)
3.2

MANAGING THE UNIT WITH THE REMOTE CONTROL

3.2.1

Remote control

The remote control supplied with the air conditioner is designed to be extremely sturdy and to ensure excellent performance
in use, but it should nevertheless be handled with some care.
For example, do not:
- leave it out in the rain, spill water on its keyboard or drop it into water
- subject it to impacts or drop it onto hard surfaces
- leave it exposed to direct sunlight
- place obstacles between the remote control and the air conditioner while using it.
Furthermore:
- if o ther d evices o perated b y r emote c ontrol ( TV, r adio, s tereo s ystems, e tc.) a re l ocated i n t he s ame r oom a s t he a ir c onditioner,
there may be interference,
- electronic and fluorescent lighting may interfere with communications between the remote control and the air con-
ditioner,
- remove the batteries in case of prolonged disuse of the remote control.
3.2.2

Fitting the batteries

The remote control exclusively requires 2 dry LR03 1.5 V batteries (not included with the supply).
Used batteries should be disposed of solely by depositing them into the appropriate collection points arranged by the Local
Authorities specifically for this type of waste.
Replace both batteries at the same time.
To insert the batteries remove the spring-latch cover on the back of the remote control.
The batteries have to be inserted according to the positive and negative pole markings in the bottom of the battery compartment.
Close the spring-latch cover after inserting the batteries.
18

USE AND MAINTENANCE (user part)