Before Using For The First Time; Installing And Connecting The Appliance; Commissioning The Appliance - Siemens TI3.1 Série Mode D'emploi

K
Before using for the
first time
I n this section, you will learn how to
B e f o r e u s i n g f o r t h e f i r s t t i m e
commission your appliance.
Only use the appliance in
Note:
frost-free areas. If the appliance was
transported or stored at temperatures
below 0 °C, you must wait for at least 3
hours before using it.
Installing and connecting the
appliance
Remove any protective plastic film.
1.
Place the appliance on a level,
2.
water-resistant surface which can
bear the weight.
Using the mains plug, connect the
3.
appliance to an earthed socket that
has been correctly installed.
After plugging in, always wait
Note:
(approx. 5 seconds).

Commissioning the appliance

Attaching milk frother
~ Fig. #
Remove milk frother parts from the
1.
bag.
Assemble milk frother.
2.
Attach the milk frother on the front of
3.
the appliance.
Before using for the first time en
Filling the bean container
This appliance can be used to make
coffee drinks from coffee beans.
Open the lid )" of the bean
1.
container )*.
Pour in coffee beans.
2.
Close the lid again.
3.
Notes
Coffee beans that have been glazed
■
or caramelised or that contain other
sugary additives block the brewing
unit. Only use pure bean mixes that
are suitable for use in fully automatic
espresso or coffee machines.
The coffee beans are freshly ground
■
for each brewing process.
Keep the coffee beans sealed and
■
stored in a cool place to maintain
optimum quality.
Coffee beans can be stored in the
■
bean container for a number of days
without losing their aroma.
Filling the water tank
Important: Fill the water tank with fresh,
cold, still water on a daily basis. Prior to
operation, check whether the water tank
has been sufficiently filled.
Carefully remove the cover of the
1.
water tank.
Use the handle to remove the water
2.
tank and then rinse out.
Fill the water tank with water up to
3.
the "max" marking.
Put the water tank back in the holder
4.
again, keeping it straight, and fit the
cover of the water tank.
11