Settings; Automatic Switch-Off; Switching The Audible Signal On/Off; Setting The Water Hardness - Siemens TI3.1 Série Mode D'emploi

en Settings
1

Settings

T his appliance has different factory
S e t t i n g s
settings. You can customise the settings
on the appliance.
If no button is pressed within
Note:
90 seconds, the appliance switches to
"Choose beverage" without saving. The
previous setting remains unchanged.
You can select the following settings:

Automatic switch-off

T he appliance switches off
S e l e c t i n g a u t o m a t i c s w i t c h - o f f
automatically at a specific time after the
last button was pressed. This time can
be selected, with settings from
15 minutes to 4 hours possible here.
Press and hold % and
1.
calc'nClean for at least 3 seconds.
Touch caffe crema button and
2.
"Automatic switch-off" will be
activated.
Touch % button and select the
3.
required time.
The following settings are possible:
15 minutes
30 minutes (factory setting)
1 hour
2 hours
4 hours
Touch caffe crema button to save
4.
the setting.
Touch calc'nClean button to exit the
5.
menu.
16
Switching the audible signal
on/off
Whenever a button is pressed, an
audible signal sounds.
This can be switched on or off.
Press and hold % and
1.
calc'nClean for at least 3 seconds.
Touch cappuccino button, and
2.
"Signal tone" menu will be activated.
Touch % button and switch
3.
signal tone on or off.
On (factory setting)
Off
Touch cappuccino button to save
4.
the setting.
Touch calc'nClean button to exit the
5.
menu.

Setting the water hardness

It is important to set the water hardness
correctly so that the appliance indicates
in good time when the descaling
programme should be run. The preset
water hardness is level 4.
You can check the water hardness
using the enclosed test strip or by
asking your local water supplier.
Briefly immerse the enclosed test
1.
strip in fresh tap water, leave it to
drip and read off the result after 1
minute.
Simultaneously hold down %
2.
and calc'nClean for at least
3 seconds.
Touch espresso button, and "W.
3.
hardness" menu will be activated.