Water Filter; Frost Protection - Siemens TI3.1 Série Mode D'emploi

Water filter

~ Fig. '
W a t e r f i l t e r
A water filter lessens limescale
deposits, reduces impurities in water
and improves the taste of the coffee.
The appliance also does not need to be
descaled so often. Water filters are
available from retailers or from
customer service.
If a water filter is inserted, the appliance
will show when this needs to be
changed. The ) symbol is flashing.
Inserting or replacing a water filter
A new water filter must be rinsed before
it can be used.
The appliance is switched on. The water
tank has been filled.
Press and hold % and
1.
calc'nClean for at least 3 seconds.
Touch espresso button, and "W.
2.
hardness" will be activated.
Touch % button and make the
3.
following selection:
with water filter
Immerse the water filter (opening
4.
facing up) in a container filled with
water until no more air bubbles rise
to the surface.
~ Fig. '
Then press the water filter firmly into
5.
the empty water tank.
Fill the water tank with water up to
6.
the "max" marking.
Place a container with a capacity of
7.
1.0 litre under the outlet.
Touch espresso button to save the
8.
setting and activate rinsing.
Insert water tank.
9.
Touch espresso button to save the
10.
setting and start rinsing. Water will
now flow through the filter.
Touch calc'nClean button to exit the
11.
menu.
Then empty the container. The
12.
appliance is ready for use again.
Operating the appliance en
Removing the water filter
If the water filter has been removed and
no new one inserted, please select the
appropriate water hardness. ~ "Setting
the water hardness" on page 16

Frost protection

To prevent frost damage during
transportation and storage, the
appliance must be completely emptied
beforehand.
Info: The appliance must be ready for
use and the water tank filled.
Place a large container under the
1.
outlet of the milk frother and push
the frother down.
Press and hold milk button for at
2.
least 5 seconds.
The LED in the button flashes, and
the appliance now heats up.
As soon as steam escapes from the
3.
milk frother, remove the water tank.
Allow the appliance to cool down.
4.
Wait until ' symbol and all LEDs are
flashing.
Use k button to switch the
5.
appliance off.
Empty the water tank and the drip
6.
tray and thoroughly clean the
appliance.
The appliance can now be transported
or stored.
The brewing unit is now secured
Note:
and cannot be removed.
15