Cleaning The Brewing Unit - Siemens TI3.1 Série Mode D'emploi

en Daily care and cleaning

Cleaning the brewing unit

~ Fig. $, ~ Fig. %
In addition to automatic cleaning, the
brewing unit should be removed
regularly for cleaning.
Caution!
Clean the brewing unit without detergent
or products containing vinegar or acid
and do not place in the dishwasher.
Remove the brewing unit:
Switch off the appliance.
1.
Open the door to the brewing
2.
chamber.
Remove the coffee grounds
3.
container.
Push the red lever up, grasp the
4.
brewing unit by the handle and pull
forwards carefully.
Rinse the brewing unit thoroughly
5.
under warm, running water.
Clean the interior of the appliance
6.
thoroughly with a damp cloth,
removing any coffee residues.
Allow the brewing unit and the
7.
interior of the appliance to dry.
Insert the brewing unit:
Hold the brewing unit only by the
1.
handle.
Push the red lever up, position the
2.
brewing unit underneath and slide
back as far as it will go. The lever
must snap into place.
Insert the coffee grounds container
3.
again and close the door.
Important: If the brewing unit has not
been inserted, or the brewing unit or
drip tray not inserted correctly, it will not
be possible to close the door.
20