Operating The Appliance; Preparing Coffee Using Freshly Ground Beans - Siemens TI3.1 Série Mode D'emploi

en Operating the appliance
General information
The factory settings of the fully
automatic coffee machine are
programmed for optimal performance.
The appliance switches off
■
automatically after a specific time.
Whenever a button is pressed, a
■
signal sounds. It can be switched
off.~ "Settings" on page 16
When the appliance is used for the
■
first time, after running a service
programme or has not been
operated for a long period, the first
beverage will not have the full aroma
and should not be consumed.
After commissioning the appliance,
■
you will only achieve a suitably thick
and stable "crema" after the first few
cups have been dispensed.
If the appliance is in use for a long
■
period of time, water droplets will
form on the ventilation slots. This is
normal.
Escaping steam is not a fault but
■
due to the design of the machine.
Before using your new appliance, you
should check and select the water
hardness.~ "Settings" on page 16
12
1
Operating the
appliance
I n this section, you will learn how to
O p e r a t i n g t h e a p p l i a n c e
make beverages with coffee and milk. It
contains information about settings,
water filters and adjustment of the
grinding level, in addition to frost
protection.
Freshly prepared beverages may
Note:
be very hot.
Preparing coffee using freshly
ground beans
You can choose between Espresso and
Caffe crema. ~ "Preparing drinks with
milk" on page 13
The appliance is switched on. The water
tank and bean container have been
filled.
Place a cup under the outlet system.
1.
Touch % repeatedly to select
2.
the required coffee strength.
Touch the espresso or caffe crema
3.
button.
The coffee is brewed and then
dispensed into the cup.
To stop dispensing the drink
Note:
before the end, touch espresso or caffe
crema again.