Display Messages; Before Using For The First Time - Siemens TE502DE Série Mode D'emploi

Display messages

The display (15) shows not only the current
operating status, but also various messages
that give you status information or let you
know when you need to take action. As
soon as you have taken the necessary ac­
tion, the message disappears and the menu
for drink selection is displayed again.
Before using for the i rst
time
General
Fill the water tank with fresh, cold, uncar­
bonated water only, and preferably use only
beans for fully automatic coffee and espres­
so machines. Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than 4,
change the setting on the appliance accord­
ingly after switching on (see "Menu settings"
Water hardness
Switching on the appliance
1. Place the fully automatic espresso ma­
chine on a l at, water­resistant surface
that can take its weight. Make sure that
the machine's ventilation slots remain
unobstructured.
2. Pull the power cord out of the storage
compartment (20) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is l ush with the edge of the
counter and either pull the cable down-
ward or push it upward.
3. Install the milk frother. Operate the ma­
chine only after the milk frother (6) has
been fully assembled and installed.
TE502_1DE.indb 23
on page 25).
4. Lift the lid of the water tank (17).
5. Remove and rinse the water tank (16)
and i ll it with fresh cold water.
Do not i ll above the max mark.
6. Replace the water tank (16) and push it
i rmly downward into place.
7. Close the lid of the water tank (17)
again.
8. Fill the bean container (1) with coffee
beans. (For preparation using ground
coffee, see "Preparation using ground
coffee" on page 27.)
9. Press the power switch O / I (9). The
display (15) shows the menu for setting
the display language.
10. Select the required display language
with the upper rotary knob (14). The
following languages are available:
Deutsch
English
Français
Italiano
11. Press the start button (10). The
language you selected is saved. The
display shows
Pull milk frother
12. Place a receptacle under outlet (6c).
13. Carefully pull out the milk frother (6) to
open it. The appliance rinses out the
milk frother (6) with water. The display
shows
Push milk frother
14. Push the milk frother (6) in to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
en de
.
.
23
29.08.2011 12:11:31