Water Ilter - Siemens TE502DE Série Mode D'emploi

de en
Switching off the appliance
If the appliance has not been used for an
hour, it rinses automatically and then
switches off (time span can be programmed,
see "Menu settings"
Exception: The appliance switches off with­
out rinsing if only hot water or steam were
dispensed.
To switch the appliance off manually before
e
this, press the off /
appliance rinses and switches off.
N.B.: If the appliance is being used for the
i rst time, a service program has been run,
or the appliance has not been operated for
a long period, the i rst beverage will not
have the full aroma and should not be con­
sumed.
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable "crema" only after the first few
cups have been dispensed.
After extended use, water droplets may
form on the ventilation slots. This is normal.
Water i lter
A water i lter can prevent scale buildup.
Before a new water i lter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water i lter i rmly into the wa­
ter tank with the aid of the measuring
spoon (18).
2. Fill the water tank (16) with water up to
the max mark.
3. Press and hold the
for at least three seconds. The menu
opens.
e
4. Press the off /
edly until the display shows
.
filter
5. Select
Activate filter
rotary knob (14).
24
TE502_1DE.indb 24
on page 25).
Shut off
button (12). The
j
e
off / button (12)
j
button (12) repeat­
j
No / Old
with the upper
6. Press the start button (10).
7. Place a receptacle with a capacity of 0.5
litres under the outlet (6c).
8. Press the start button (10).
9. Pull the milk frother (6) to open it.
10. Water will now l ow through the i lter to
rinse it.
11. Push the milk frother (6) in to close it.
12. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the i lter simultaneously acti­
vates the setting for the
display.
The i lter is no longer effective when the
display appears, or at the
Change filter!
latest after 2 months. It needs to be re­
placed for reasons of hygiene and so that
there is no build­up of limescale (this could
damage the appliance).
Replacement i lters can be obtained from
retailers (TZ70003) or from customer serv­
ice (467873). If no new i lter is used, turn
the setting to
filter No / Old
Note: You can use the i lter indicator to
mark the month in which you inserted the
i lter. You can also mark the month in which
you will need to replace the i lter next (at
the latest after two months).
Change filter!
.
29.08.2011 12:11:31