Water Ilter; Menu Settings - Siemens TE506RW Série Mode D'emploi

Water i lter
A water i lter can prevent scale buildup.
Before a new water i lter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water i lter (20) i rmly into the
water tank with the aid of the measuring
spoon (19).
2. Fill the water tank (17) with water up to
the max mark.
3. Press and hold the
for at least three seconds. The menu
opens.
e
4. Press the off /
j
edly until the display shows
filter
.
Activate filter
5. Select
rotary knob (15).
6. Press the start button (10).
7. Place a receptacle with a capacity of 0.5
litres under the outlet (6a).
8. Press the start button (10).
9. Water will now l ow through the i lter to
rinse it.
10. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the i lter simultaneously ac-
tivates the setting for the
display.
The i lter is no longer effective when the
Change filter!
display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement i lters
can be obtained from retailers (TZ70003) or
from customer service (467873). If no new
filter
i lter is used, turn the
No / Old
.
e
off / button (13)
j
button (13) repeat-
No / Old
with the upper
Change filter!
setting to
Note: You can use the i lter indicator to
mark the month in which you inserted the
i lter. You can also mark the month in which
you will need to replace the i lter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
i lter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.

Menu settings

You can adapt the appliance to your indi-
vidual needs in the menu settings.
e
1. Hold the off / button (13) down for
j
at least 3 seconds.
e
2. Press the off /
j
ly until the required menu item appears
in the display.
3. Select the required setting with the up-
per rotary knob (15).
4. Coni rm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to
and press the start button (10).
en de
button (13) repeated-
Exit
7