Rear - Sony UP-2100P Mode D'emploi

Rear

REMOTE
1 2
1 REMOTE 1 connector (special mini
jack) (55)
Used to connect the RM-5500 Remote Control
Unit (not supplied) to be used as wired remote
control unit.
2 REMOTE 2 connector (stereo mini
jack) (55, 76)
Used to connect the RM-91 Remote Control
Unit (not supplied), the FS-20 or FS-36 Foot
Switch. Or input remote control pulse signals
for automatic printing.
3 INPUT (input signal) connectors (53)
Used to connect the video equipment
supplying the source image.
Connector Connectable equipment
S-VIDEO Video equipment with Y/C separated
output connector.
VIDEO Video equipment with composite video
signal output connector
Refer to "Important safeguards/notices for use
in the medical environments" on page 2.
INPUT OUTPUT
S-VIDEO VIDEO S-VIDEO VIDEO
4 OUTPUT connectors (54)
Used to connect the video monitor.
Connector
S-VIDEO
VIDEO
Refer to "Important safeguards/notices for use
in the medical environments" on page 2.
5 ~ AC IN connector
Used to connect the printer to a wall outlet
with the supplied power cord.
6 Equipotential ground terminal
connector 1
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environment" on page 2.
~ AC IN
Connectable equipment
Video equipment with Y/C separated input
connector.
Video equipment with composite video
signal input connector
85
Others