Greasing The O-Ring Of The Cassette Vent; Maintenance; Spare Parts; Replacing The Cassette Seal - Dometic Saneo B Notice D'utilisation

Saneo B, Saneo C
7.5

Greasing the O-ring of the cassette vent

➤ Take the adapter (fig. n 1, page 10) off the cassette.
➤ Grease only the attached O-ring (fig. n 2, page 10) with silicone grease.
8

Maintenance

This chapter describes maintenance that may be performed by the user. Have all
other maintenance and service work performed by qualified personnel.
8.1

Spare parts

Spare parts can be obtained from the customer service of the respective country.
All the accessories are available from specialist dealers. If you have any questions,
please contact the dealer or your service partner directly.
8.2

Replacing the cassette seal

➤ Pull back the cover so that the seal is accessible (fig. o, page 11).
➤ Remove the support ring and the seal (fig. o, page 11).
A
NOTICE!
The seal must be positioned uniformly in the opening so that the
cassette is sealed and the slider can move easily.
➤ Insert the new seal (fig. p, page 11).
➤ Place the support ring in the provided groove in the cassette seal (fig. q,
page 11).
!
CAUTION! Danger of crushing!
Do not reach into the opening when you close the cover.
➤ Close the cover (fig. i, page 9).
EN
Maintenance
27