Dräger X-am 5600 Notice D'utilisation page 26

 Connect the test gas cylinder with the calibration cradle.
 Vent the test gas into a fume cupboard or into the open air (with a hose
connected to the second connector of the calibration cradle).
Risk to health! Never inhale the test gas.
Observe the hazard warnings of the relevant Safety Data Sheets.
 Switch on the instrument and insert it into the calibration cradle.
 Press the [+] key and keep it pressed for 5 seconds to open the calibration
menu, enter the password (password on delivery = 001).
 Use the [+] key to select the single gas adjustment function. The symbol for
span adjustment » « flashes.
 Press the [OK] key to start the channel selection.
In the case of the CO channel there is a 2-stage calibration routine:
2
The zero adjustment takes place first and is then followed by the span calibration.
– The display shows the gas of the first measuring channel, e.g. »CH
 Press the [OK] key to start the adjustment function of this measuring channel,
or use the [+] key to select another measuring channel (O
CO - ppm, etc.).
– The test gas concentration is displayed.
 Press the [OK] key to confirm the test gas concentration or use the [+] key
to change the test gas concentration and complete the process by pressing
the [OK] key.
– The measurement value flashes.
Open the test gas cylinder valve to let gas flow over the sensor with a

volume flow of 0.5 l/min.
– The displayed, flashing measurement value changes to the value according
to the supplied test gas.
When the displayed measurement value is stable (after at least 120 seconds):
 Press the [OK] key to perform the adjustment.
– The display containing the current gas concentration changes with the
display »OK«.
 Press the [OK] key or wait for approx. 5 seconds to end the adjustment of
this measuring channel.
– The next measuring channel is displayed for adjustment if necessary.
– After the adjustment of the last measuring channel, the instrument changes
to the measuring mode.
 Close the test gas cylinder valve and remove the instrument from the
calibration cradle.
26
WARNING
NOTICE
- Vol.-%, H
2 2
If a fault has occurred during the span adjustment:
– The fault message »
respective sensor instead of the measured value.
 In this case, repeat the adjustment.
 Change the sensor if necessary.
Cleaning
The instrument does not need any special care.
 Dirt and deposits can be removed from the instrument by washing it with
cold water. A sponge can be used for wiping if necessary.
Abrasive cleaning tools (brushes etc.), cleaning agents and cleaning solvents
can destroy the dust and water filters.
Carefully dry the instrument with a cloth.

Maintenance
LEL«.
4
The instrument should be inspected and serviced once a year by suitably
S - ppm,
qualified persons. Comparisons:
 EN 60079-29-2 – Gas detectors - Selection, installation, use and
maintenance of detectors for flammable gases and oxygen
 EN 45544-4 – Electrical apparatus used for the direct detection and direct
concentration measurement of toxic gases and vapours - Part 4: Guide for
selection, installation, use and maintenance
National regulations

Recommended calibration interval for measuring channels O
NO and CO: 6 months.
2
Recommended calibration intervals for the measuring channel IR Ex/CO
12 months.
Calibration intervals of other gases: see Instructions for Use of the respective
DrägerSensors.
See the Technical Manual for details of spare parts.
Storage
 Dräger recommends storing the instrument in the charger module
(order no. 83 18 639).
Dräger recommends checking the charge of the power supply at least every

three weeks if the instrument is not stored in the charger module.
« appears and » « is displayed for the
CAUTION
, H
2
S, H , SO ,
2 2 2
:
2